Solar / Wind Turbine AC or DC Current Transducer Hall Effect Sensor to Measure Amps LabVIEW Compatible
Code : B004EZX3AG
Category :
Rating : 
* Special discount only for limited time
Product Details
- Amazon Sales Rank: #118938 in Lawn & Patio
- Brand: Measure Current
- Model: H-ACDC-70 LabVIEW
- Dimensions: 2.00" h x
3.00" w x
3.00" l,
1.00 pounds
Features
- Easy to install, measures up to ±70 Amps DC or AC ( Puts out ~0.033mV per amp per winding through the sensor)
- Measure current from solar panel, wind turbine, battery charger,
- Unlike a current shunt, this sensor is electrically isolated from your monitoring system and does not give off heat
- Comes with 5 feet of shielded 4 wire cable - size 22 AWG Stranded
- Output is compatible with LabVIEW / Labjack / Digital Multi Meter
Solar / Wind Turbine AC or DC Current Transducer Hall Effect Sensor to Measure Amps LabVIEW Compatible
Product Description
The H-ACDC-70 allows you to easily measure current through a wire running from a solar panel, wind turbine, battery charger, fuel cell, pedal power generator, inverter, radio, blender, or paddle wheel. SIZE: 3" x 2" POWER CONSUMPTION: .5 Watts The H-ACDC-70 has an output range compatible with most data loggers like the ones sold by LabJACK, National Instruments, Hobo, dataq, LabJACK, and more. What's in the box: (1) The H-ACDC-70 Sensor, 5 Feet of shielded cable 4 wire 22 AWG, 2.5mm power connector. The output range of this current sensor is shown on the graph in above image. As you can see this current sensor has a linear response. This current sensor will change its output approximately ~0.033V for every Amp of current it detects. When there is no current flowing through the sensor it puts out a default Voltage of 4.0V DC. If the wire you are monitoring has 10 amps flowing through it, then the current sensor will output about 4.330 volts DC. To increase sensitivity simply loop the sensed current path wire through the sensor as many times as needed to increase the gain to the desired level.
You will need to first secure the sensor using the four screw holes, and then hook up the green connector to your data logger or your hand held volt meter. Then you will need to pass a single wire through the round doughnut shaped sensor is shown in the picture above. The last step is to provide this sensor with operating voltage through the black power connector (2.5mm). This sensor needs 12V to 30V Volts DC to excite the sensor.
Customer Reviews
Most helpful customer reviews
See all customer reviews...
Solar / Wind Turbine AC or DC Current Transducer Hall Effect Sensor to Measure Amps LabVIEW Compatible. Reviewed by Bobby P. Rating: 4.6
This Page is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to Amazon.com
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED "AS IS" AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.
